You can end up with a door with uneven gaps around it that does not latch correctly if you do not hang a door correctly. One of the most common installation problems when hanging a door concerns floors that aren?t level under a doorway. You could have real problems with the latch lining up properly if you fail to trim the jamb to compensate for the difference created by a slightly sloping floor.
Make sure to always check the width of the opening before you order your door. Make sure the width of the opening is always 2 to 2-1/2 inches wider than the door. This extra space will be used up by the jambs and the shims and is needed in order to hang the door properly. You will need a 30-inch pre-hung door if your rough opening measures 32 inches.
The pre-hung door jambs must then be checked for length. You will have to minimize space and both sides of the jamb might have to be trimmed should they turn out to be too long. Make sure to allow one-half-inch space for the door to clear the floor.
You should also check the vertical sides of the rough opening as they should be plumb, which means they should be exactly vertical or perpendicular to a level horizontal line. Some small variations from plumb are common, but openings that have a trimmer stud more than 3/8 inch out of plumb from top to bottom will translate your home improvement task of installing a door to a ?mission impossible.?
The door must be measured and trimmed carefully and precisely before installation. The necessary techniques can be easily mastered with just a few home improvement skills and some basic carpentry tools. It will take about an hour and a half to install your first door but once you know what you are doing, the second one will go in twice as fast.
If a door closes tightly and quietly and doesn?t swing open you know that it has been properly installed. A well-installed door has been trimmed in such a way that there is a very small aperture of just under one-half inch next to the jamb. Where the hinges sit or the lockset slides great care must be taken when cutting the different holes or slots in the wood. The door won?t close properly and might spring open if the cut is too deep and it will creak and scrape. To create the perfect mortise, a sharp chisel and a steady but light hand is required.
View Portland OR Real Estate and also learn more about quality real estate agents in Portland. In addition, we also have a website that allows you to search for Lakewood CO Realtors. These sites will assist with locating real estate.
Source: http://prudentarticles.com/home-improvement/doors/some-tips-on-how-to-hang-a-door
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.